Hatteras Gt45x (2020) For sale

This 2020 GT45X is ready to take offshore adventures. ONE SHOT offers a stylish, low-profile exterior with a spacious cockpit and a 2-cabin, 1-head layout.
Ideal for any owner-operator, ONE SHOT delivers on the Hatteras tradition of unmatched build and ride quality, while equipping all those aboard with a lavish setting to relax, entertain and pursue life's adventures.

Exterior Finish & Construction
Isophthalic/NPG gel coat, exterior layer
Hull and superstructure painted with premium linear polyester/polyurethane
Polymer/copper based anti-fouling bottom paint
Boot stripe, linear polyester/urethane coating
Decks, non-skid surface, polyurethane paint with polymeric beads
Resin-infused solid fiberglass hull bottom and composite hull sides with premium vinyl ester resin and blister resistant gel coat below the waterline
Molded fiberglass longitudinal stringers with steel engine beds
Resin-infused bulkheads and interior decks using crosslinked foam coare
Integrated fiberglass hardtop with single pane windshield with windshield wipers and aft soft enclosure

Hardware & Miscellaneous
Hand-crafted Rift Cut White Oak interior with satin finish
All interior hardware in polished chrome
Anchor, 25' of galvanized chain, 250' anchor line
Four polished stainless steel spring cleats, robust designed with through bolt mounting in aluminum backing plates
Two polished stainless steel bow cleats and chocks, two stern cleats and hawse pipes, through bolted in aluminum backing plate
Polished, anodized aluminum bow rail
Deck plates for fuel and water fills and waste pump out
Bronze rudders with stainless steel shaft
Manganese bronze rudder ports with composite bearings and dripless seals
Manganese bronze struts with custom bearings for noise reduction
Alloy 22 high-strength propeller shafts with proprietary keyway
Manganese bronze propeller shaft couplings
Dripless shaft seals with spare seals
Nibral high-performance propellers
Electric Bow Thruster. 10" diameter 130 kg (286 lbs) thrust
Dual air horn
Transom zinc
Stainless steel trim tabs
Underwater lights (2)
Air conditioning 18,000 BTU capacity with reverse cycle heating

Engine Room & Bilge
Finished engine room and bilges
Rubber deck mat between engines
Insulation in engine room ceiling, for noise mitigation on helm decl
AC fluorescent lights
DC LED lights
DC blowers
17 kw freshwater cooled diesel generator
Twin diesel, freshwater-cooled main engines with electronically controlled marine gears, neutral interlocks, and exhaust silencers
Fiberglass fuel tanks constructed with fire retardant resin
United States Coast Guard type A1 UL Marine listed fuel lines
Fuel primping pumps
Fuel filters and water separators for engines and generator
100 gallon water tank
Pressurized 24V DC freshwater pump
Water manifold with centralized shut-off valve for sinks and showers
20 gallon water heater
43 gallon holding tank plumbed for dockside pump-out
Sealed shower sump pump with automatic float switch
Individual sea chests for engines and genset
Sea chests for water makers, air conditioners and raw water pumps
Centralized drain system with single thru-hull
Stainless steel steering tie bar with pivoting self aligning ball joint connection at all cylinder and tie bar connections
FM200 fire extinguishing system for engine room; including automatic and manual discharge, with audible and visual discharge signals
Battery distribution panel with voltmeter
Oil change system for engines, gears and generator

Electrical Systems
Systems monitor display with visual and audible signals for exhaust temperature, alternator, battery voltage, high bilge water, fire warning in engine compartment, fire extinguisher discharge in engine room, AC power loss, smoke and carbon monoxide detectors, and holding tank 3/4 full monitor
(2) 24 volt bank of heavy-duty, 12 volt marine batteries mounted in a fire retardant fiberglass box
Tin coated wiring with insulation, labeled an